I wasn't sure what forum to put this in, but since I am attempting an N Scale plan, it kind of makes sense to put here. Like I said above, I am still attempting to draw out my layout in Atlas RTS 7.0 and am finding it hard to believe that the only radius curves they have in there are 11" & 19" radius. What about 13.75" or 15" radius? Does anyone have any better directions on how to may flex track bend on the software? I always end up with a check mark or a V for my curves. Any help would be greatly appreciated!
RTS 7.0 assistance Maybe here? http://www.trainboard.com/grapevine/forumdisplay.php?f=183 Sounds like you've loaded the library of Atlas code 80 track rather than code 55? Are these step-by-step diagrams helpful?
You were correct in your assumption! Yes, thank you so much. Funny thing is, I checked out Atlas' site last night. They have RTS 8.0 available for download. So far, it is much easier to use than 7.0 was. Now to figure out the height thing, that is so difficult to use. I guess I am stuck to my sketchbook and template to draw my line!
