This shows up every so often so I thought I post it in the hope that it clarifies some of the question that turn up ever so...
Go to the HOW TOO section of Train board and click on this, or from here. if you just get the books re click on the part that is NOT underlined to...
I have had the same problem with tight joiners. So what I come up with is to get a piece of rail sharpen/deburr it a little on the end and put...
Go to the (How Too ) part of the trainboard forum and look under Wire Dwarf & Panel Control Signals to a Atlas Turnout I think this is the...
----Just a thought for you box go get a cake pan that fits your needs 8x10 or whatever and put your pannel board on top and then the back side...
----I have been looking for the same switch and I found them in Russia at chip dip http://www.chipdip.ru/product/ps001-n11nawurug.aspx I got 20 of...
Try this web site this may give you a idea http://www.youtube.com/watch?v=UZHL2...eature=related
[ATTACH]I understand what you are trying to do I too hand lay my own turnouts. When I first started I got the jig for the 16-14 radius turnout I...
[ATTACH]Here's what I did Hope this get a idea going for you[ATTACH]Next time around I,m going to install a 3-way turnout ---left and right around...
For the underneath side you could go to home depot and get some lower kitchen cabenets for you stuff-- make sure you have rollers on them so you...
---- If and when you decide that it IS impossible you could always put a dedacated boxcar behind the engine and install the decoder in there. Just...
May I sujest using a PM-42 it has 4 positions, From looking at your picture you not that far along so it a possibility that this would be...
You can have panel control with the DS-64 just by adding a wire/s to one of the outputs also these can be computer controled and routed so can...
For what it's worth get a good box car%%^^ and put the decoder in there and run it behind the engine, of coarse this car will be (dedicated)
To get to the page for the turntable you have to click on the first half of the web page THAT IS NOT underlined
Here is some more information on wiring turnouts and what happens to the polarity when the turnout is thrown from the normal to the Reverse...
QUOTE=Alan C.;844359][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] Here are more examples for shoes these are the one's I engineered and installed for...
[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] Here are more examples for shoes these are the one's I engineered and installed for UP Railroad its the...
I worked on this Bridge If its the one just across from the old Yuma prison. That shoe there is a expansion shoe also these shoes adjust the...
Just get a regular joiner and cut a slot into the center----put the two rails together and tap with a tack hammer till the top of the rails are...