Looking to trade...
I recently came across some videos by MC Fujiwara. Pretty good tutorials with some awesome music lead ins. Here's a link for the small cabins he...
@Bikerdad, your right. I need a bunch more cars to make a decent train. I'm thinking at least 15 covered hoppers, 15 hi cube boxes, some...
I haven't posted here for a while but I came across a situation that I must share. Perhaps you can use this excuse sometime too. I don't...
Huh. I've been into three hobby shops (2 RR specific and 1 multi hobby) in Portland and have felt welcome in all. One of the RR specific one...
Bummer. I had another module ready to go. Oh we'll, see you at the next met up. Eric
Wow. Those giant gaps in my track work are prototypical. They are evidence of sabotage by the Germans.
I have a small table saw that works pretty good but trying to cut a sheet of plywood would be difficult and dangerous. What I do if I need...
What about using the ends from MT. Aren't they available as a separate part?
Bob, I think you're idea of too many pc ties might be what I need. All my turnouts worked fine when they were installed but I think neglect and...
On another note, your power lines look really good too.
I've finally had some time to work on the layout after being on hiatus from it for a year or so. When I started it I thought it would be great to...
There have been two things that have affected my buying, or lack thereof. First is the cost. I was in a hobby shop the other day and thought...
Does that smell anything like creosote? It would be cool if it did. Eric
Love the parallel track shots. I haven't seen that before. I remember seeing one of those at Caboose Hobbies a few years back. IIRC it runs on...
Jim, A daylighted tunnel is when the railroad decides to excavate the ground above the tunnel to essentially make a deep cut. It's used quite a...
I haven't been too active on the forum lately so this might have already been discussed. But I ran across these today while browsing:...
Luckily I didn't get injured, but I forgot to put on eye protection when using a dremel cutoff disk. The disk exploded as they do and pieces went...
I can't find a link to it but I've seen a layout that used extruded foam to support the layout. The layout was a standard 4' x 8'. To support...
Rick, I remember going through that article several times. I was fascinated by the nolix idea. I think you and I discussed it several times in...