Badger I think has one.
Why is that?
Just look on the bottom to see if it has a split frame(non-DCC) or not and that will be your answer.
Was it near TU?
Are these your own etchings?
I already emailed Chris my two order commitments for Rock Island! Be sure and send him an email!
I would buy one just to run slow freights.
Was it purchased used or new? If it is used, it's possible it is from the first run which has known decoder issues.
I am looking very forward to this as I haven't been the most happy with some recent paint jobs using the Tamiya tape. Any estimate as to when you...
They key is to let the drill bit do the work and do not apply any extra pressure. These bits snap easily!
Good to see you back and modelling again, Vadim! I had been wondering where you went since I enjoyed all your videos of your trains that you...
Yes I just got a 100pack of that resistor on ebay for like $5 or something nuts and so all my projects are covered for a while now that require...
You can file the front down, it will just take a while. You can probably use a pre-wired 402 LED.
Did you get a hold of Roberto recently?
Any hints for your project?
Then give an explanation.
Well then I'm not sure what it would be then. I tried the cookie method and try as I might, I didn't alter the vote.
It's IP based, so it won't matter on the cookies. It's people with ISPs that provide users with dynamic IP addresses that can vote multiple times.
You guys had plenty of opportunity to use Intermountain's stuff, yet woo woo woo and moan at the colors not being right despite no real world equipment...
Someone mentioned that the truck centers or wheelbase(don't remember which) of the TA is the same as the FP7. So only a new shell would be needed....