Probably because most processors used in DCC-decoders can directly provided a ground-output that can be used with either a ~5v-Led or a ~12v-bulb.
This uncompleted open-source Direct-Bluetooth-Train-Control project is ended! It is beyond my diminished abilities to complete. I will be...
The android apps on both my android devices would run the loco with loco-firmware 3.21. But my apps on my android (4.4.4) phone would not work...
I browed an ios device, downloaded the BlueRail ios app, and successfully updated the loco-firmware to 3.45. The loco ran fine with the ios...
The un-updated Loco-firmware 3.21 apparently has a ~400 Hz motor drive that is fixed in the updated Loco-firmware 3.45. The problem is getting...
[ATTACH] A picture of the BlueRail/Bachmann HO-FTA board. Had an opportunity to buy a new one for $46-shipped to check out. The App installation...
I good design would also use the USB connector for firmware-upgrades of the Rokuhan controller (and maybe even firmware-debugging). Bob
At 1:10 in the video of the original post in the other similar thread, there is a unit that appears to be a Bluetooth-audio-receiver plugged into...
At 1:10 in the video of the original post, there is a unit that appears to be a Bluetooth-audio-receiver plugged into the audio jack of the...
If so then something must be getting lost in the translation for their information states this “*Operate your car by wireless connection via...
Apparently the “*Operate your car by wireless connection via third-party Bluetooth audio receivers (sold separately)” uses the same direct audio...
Thanks, I missed that. Kind of unusual to demonstrate a tethered-throttle when you have a wireless-throttle. Bob
Looks like they are using the “sound” output from the tablet. Probably using one channel for sound to the controller and the other channel for a...
[ATTACH] Pictured are 4 “production” OS-DBTC “boards” that are basically like 4-function HO-DCC-decoder-boards only without a direct...
