NCE - light-it used as signal controller

Bourkinafasso Mar 1, 2021

  1. Bourkinafasso

    Bourkinafasso TrainBoard Member

    388
    206
    25
    Hi,

    I'd like to use some light-it decoder as signal controller. Having a Lenz dcc I assume I have to use them as accessory decoder. + = green / - = red

    The problem I have is I can light all fonctions together + is all on (red and green) and - is all off . Can't figure how to change this to one light is on while the other is off...

    Any help would be appreciated .

    Thanks guys and take care.

    Envoyé de mon SM-G970F en utilisant Tapatalk
     
  2. BigJake

    BigJake TrainBoard Member

    3,259
    6,173
    70
    I have no experience with Light-It, but I have studied the manual a bit... A very interesting and capable product!

    I would not assume you cannot program/access them as loco decoders. I don't see how choice of Command Station affects that. I'm not saying doing so would be beneficial, just that it should be an option, regardless of CS.

    From the manual, it appears that what behavior you get when you activate the output(s) is separately programmable. Perhaps what you are seeing is just a default behavior?
     
  3. Bourkinafasso

    Bourkinafasso TrainBoard Member

    388
    206
    25
    Hi bigjake,

    You're right all outputs are separately programmable but seems to be "on" together...

    There's a nice video on YouTube showing what you can do

    But it doesn't say how....

    Envoyé de mon SM-G970F en utilisant Tapatalk
     

Share This Page