Hello folks, i'm writing from Brazil. I have a small layout, running DCC++EX on a Arduino Mega 2560 + Derek Robot Motor Shield, connected over USB to a PC with Rocrail. 12 turnouts are connected to Arduino pin-pairs. Everything runs great when I using a older (pre 3.XX) version of DCC++EX. But then, a few days ago, I decided to upgrade to version 3.10. Surprisely, outputs with pin n° 26 or higher stops working (8 turnouts at all). Locos running normal, and turnouts connected to "lower" pins also. Is there any compability issue envolving Rocrail and DCC++EX 3.XX ? On the monitor Rocrail sends correct DCC commands. Or are the outputs limited to 25 instead of 50+ possible on the Mega?
Hi Lukas, Go here, click the download button and follow the instructions for the development build by renaming the folder when it unzips. If you upload that, it should work. I would delete the files in your CommandStation-EX folder (except for your config.h file) before unzipping. That should fix it. https://dcc-ex.com/download/commandstation.html#latest-dcc-unreleased-development-version Fred DCC-EX
