I had a DZ143 installed and for some reason, I cannot program it in Page Mode, only Dir mode. When I try Page Mode, the message "NoPg" appears. Anyone have input on this? I am using a Chief and a DT400 or DT100.
Sorry Harold, but I'm not familiar with that decoder. Nontheless, it is not unusual for individual decoders act cranky with various types of control systems. good luck
I have also seen it on DZ143s and DN163a0s. I am using a Chief with DT100s. I just carried on in DIR mode and everything works okay.
After some discussion with Digitrax, I was told to use OPS programming on the main, using a DT400. I did this and after some trial and error, I was able to get a 4 digit address to stick.