I haven't been well these past couple of weeks so I haven't had a chance to have another try at programming my Bachmann locos until last night. I...
Chubak_007, Thank you for the reference. That helps a lot. I looked at using CV17 and CV18 when I was programming my other locos and couldn't...
I had a few minutes free just now and decided to look at Bachmann, USA, web site. Their discussion forum had the following two posts (the second...
Doug, According to your reference, if I'm reading it correctly, the presence of the decoder for Service Mode instructions (programming) is...
Doug, You say the problem is not that of the Zephyr. Fine. With the 1 K resistor in place, the Zephyr is looking at two electrical circuits in...
I have three Bachmann locos with factory-fitted decoders and am unable to change the loco address in any one of them with my Digitrax Zephyr. I...