I use both Autocad and 3dplan-it. I would not use 3d-planit if some one would make a good block library of buildings, switches, etc.. for...
Given that the Altas Engine came pre-equiped with a Lenz Decoder, I think I will pull the hood off, and see if I there are any wiper connections...
Along the same lines, does breaking-in an engine make them run better at low speeds? I am relitively new to N scale, and my only running...
I am in the process of setting up a small switching layout in N scale, and I am going to use Digitrax DS44 decoders with tortoise switch machines....
You may want to run a search for shinohara on this board, and the Atlas railroad forums. When I was researching what brand of turnout's to...
I know I would be interested in a ship building primer. I am planning a fishing port for my next layout, and I am going to have to do some...
Nice work on the ship. I am considering putting a port on my next layout, but it would be strickly a fishing port, and the RR would be serving a...
After reading some of the trollyville site, I may have to build some test track. If I were to build some of the track to scale they show on their...
That is a great site! Thanks for the link. I hope to soon have some track plans up for comment in the layout section. I am on about the 5th...
I am in the process of planning an N scale layout that will include a rather cramped port area. A lot of the rail in this area will be run in the...
