Hi all, I've just been given an oldish "Raildriver" controller designed for use with PC train simulator programs (see http://raildriver.com/)....
Yes, thanks Jirka your advice was correct. I was following the advice from post #21 which I thought would work. All's well that ends well....
Update to my post #90: I completed a fresh install of both JMRI (4.4.R1ccf76B) and DCC++ Basestation (1.2.1+) and generated a simple loop layout...
Further update (ref post #80 and #87) with an interesting observation: So yesterday I was working with my JMRI/DCC++ setup trying to see if I...
Thanks Scott, I've seen that TwinDad has deep knowledge of JMRI/DCC++ interaction and look forward to any advice he can provide. (I don't want to...
Update on my request for help at post #80 (key issues repeated in next para.) "The problems: (a) when I click on the panel diagram turnout circle...
Jirka, In DCC++ Traffic Monitor window, select the "Show raw data" checkbox and you should then see the commands you send to your turnout servos....
Just to correct my earlier post, the monitor window I mentioned is actually the "DCC++ Traffic Monitor" and it of course monitors the serial bus...
Jirka, thanks for your response. I tried the strategies you suggested but the problem remains. This time I started using the "DCC++ Monitor...
Hi All, I've been reading Trainboard for 3 or 4 months now after finding it while researching the DCC++ system. Finally decided to sign up to get...
Hi I'm a new member seeking help, hopefully I'm in the right thread. I've been reading the DCC++ and JMRI posts for a few months now and just got...
