you can control the throw of servos to not over drive them by simply changing the sstart and sstop on the sketch. they can also be reversed the...
Hey for what its worth take a look at my setup on youtube under bobbyboy1962, its a quick summary of the 3d printed and servo setup using a...
change the int SSTART and int SSTOP values to control the servo travel. I have these set at these numbers as a reference . 0 and 180 would be full...
this is the thingiverse thing, use my remix for the base unit as it allows you to move the micro switch for better control. Servo Turnout Motor...
so based on what im reading i should be able to network the arduinos and send them into jmri? i may be biting a big chunk on this one lol
yea i got it but still getting this request for member error
I have the same error with Bobs code so it must be something im doing. I am also a copy and paste guy
ok got it. Now it wont compile lol. Arduino: 1.8.4 (Windows 7), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)"...
oh wait i see. I have the varspeedservo.h but where do i put it? in the sketch folder?
Arduino: 1.8.4 (Windows 7), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)"...
The setup in the video was for my benefit to see if what i was thinking would actually work. The servos will be attached under the bench work and...
Hello sir. I finally had a chance to add your code and when i verify i get an error msg of, request for member 'write' in 'servo', which is of...
Wow. Thank you very much. I will try this and let you know how it turns out. Now go get some rest, Bob
// MRH 6 Switched 6 Servos with Pushbuttons & LED Indicators // G. Bunza 2016 // #include <SoftwareServo.h> #define numpins 6...
now trying to figure out how to make the servos move slower in the arduino sketch.
this is the link i think, [MEDIA]
YES! success so far with my attempt at arduino controlled servos for turnouts. I am just posting a video to youtube showing what i have....
I have just setup an arduino and a servo shield, i have 3d printed the holders and have tried one and it works great. Have also got serup from...
