I have tried that still not sure what I am doing wrong lol Sent from my iPhone using Tapatalk
very nice i was just happy to get my loco programmed on the original lol I did DL Greg's to test my hardware seeing as I cant get jmri working...
I was becoming very curious if my base station was actually working correctly or if it was something with in JMRI I downloaded the DCC...
So I changed out the shield finally got a L298 shield and I now can read and right to the loco just can’t control them. Lol was hopeful that...
Sorry had it wrong track has 10.3 ac Sent from my iPhone using Tapatalk
Same thing using 4.10 :( Sent from my iPhone using Tapatalk
I will have to check That... Sent from my iPhone using Tapatalk
No joy :( tried every number between below five I get no response from locomotive between 30 and 8 i’ll either get no response from locomotive or...
I will give that a try did not know to low could be an issue :) Sent from my iPhone using Tapatalk
I get the no acknowledgment from locomotive (308) Sent from my iPhone using Tapatalk
Changed the threshold down to 5 now when I search I get, Mfg 255 Version 255 no such manufacture defined That happens with both locos I have....
I do have the correct shield selected and I have checked my traces now the odd part is that with an ohm meter all traces show that they are cut as...
I will try look at that here in a in a bit! Thank you Sent from my iPhone using Tapatalk
So when I do this the shield shuts down power to the track led notifier on the shield turns off. Inside jmri the power switch stays on does not...
I have tried both Sent from my iPhone using Tapatalk
I will check that tonight when I get home tonight!!! Thank you!! Sent from my iPhone using Tapatalk
Yes I have double checked that and it all checks out and set to dcc++ :( Sent from my iPhone using Tapatalk
Here is what I have going on Arduino UNO and Pololu motor shield JMRI running on a raz PI. All seems well track power turns off and on by using...