They are Arduino decoders running servo's thus the 5v
I apologize if this topic has been already posted but I have not been able to find an answer to my problem. When I have a locomotive running on...
I got a dcc monitor setup and found that when I put a turnout address in the turnout control (action/turnout) and hit the throw or closed command,...
I'm using Ruud Beor's decoder sketches which are accessory versions, I was only using Geoff's dcc interface for talking to the arduino. I am...
So I have made an interface circuit using the Dave Falkenburg's design and verified that it worked using my dcc system. I connected to my dcc++...
I verified that all the settings were set to dcc++. I did realize that the dcc interface circuit I am using is based off of the circuit from Geoff...
Unfortunately that does not look like the issue I am having. The decoders are already programmed with address's and work fine with dcc. switch to...
I will check it out Thanks Pieter
Hi all, New to TrainBoard and DCC++ I know this thread is older but am having the same problem with trying to get a Ruud Boer decoder to respond...