Hello Sven, My name is Alan Lautenslager. I am located in the USA. I find myself going back to your postings for your wonderful C-25 Nn3. I am...
Doubt this will happen. Last posting 2019.
Any more information and updates on this project? Thank you.
So I guess the answer to the original question is NO!
best way to PM you?? Alan in MN
FYI for those looking at posting. Problem solved thanks to lyncher. File extensions were hidden there for when I renamed the original file it...
GOOD CALL ! That was indeed the problem. Thank you very much! Alan
The file is present in the folder and it shows config.h
Lets try this: CommandStation-EX:12:10: fatal error: config.h: No such file or directory ResolveLibrary(config.h) #include "config.h"
I do not see a "COPY ERROR MESSAGES" button
//////////////////////////////////////////////////////////////////////////////////// // © 2020, Chris Harlow. All rights reserved. // // This...
Powered down the Arduino and powered up again. Uploaded the code and it errored out again. Wish I could figure out what I am doing wrong!
Went back and tried to do the manual method and it still errored out saying that config.h does not exist. Then did auto install and it works!
Did all you mentioned. DIO2.h installed. Just used the autoinstaller and it appears to have loaded. Not sure what to do from here to verify that...
DCC++ Master loads just fine.
In addition I noticed that after the error upon uploading that the Arduino file with the blue circle next to it is deleted from the list of files...
Just to make sure this is what I did. Unzipped the file. Went into the folder and located the file called config.example.h and renamed it to...
Not to sharp on files etc. Do you mean I should go into the code and rename it "config.example.h" and should I also rename the file name the...
Downloaded the latest code today and tried to install in my Arduino Mega R3 ( not a clone ) When I attempt to upload it to the board I get an...
Playing with the Arduino family is a bit new to me. Followed the steps to load in the code to my Mega R3 and it comes up with an error that...