Thanks for all the help so far Dennis! I`ll have a look! Greets, Marco
In the tabs "Connections" and "Defaults" I assigned everything to DCC++. I could not find anything else to switch to DCC++. Also for the first...
That did the trick as for DecoderPro! I apparently did not assign anything to DCC++ in the Preferences for DecoderPro. Now I did under the tab:...
Power supply gives 14 Volt. On track AC: 17.6V and DC 0.4V What I also noticed is that in the DecoderPro window, in the lower left corner, it...
1. After starting JMRI , bring up DecoderPro. 2. On the top of the screen you will see a icon which will either say "Unknown, OFF or ON". Click it...
Hmmmm.... After a lot of failed attempts, I still couldn`t figure out what the problem is/ was. But....then it sprung to my mind: what if there...
No unfortunatly not. I followed these instructions: [MEDIA] And with the step of detecting the decoder, it gives a 308 error. Also after trying...
Hi all, At first: Thomas, thanks for pointing this out!! Unfortunatly, I (still) have the same problem... Windows 7, Arduino Uno, Arduino (Deek)...