Yeah, the weird thing is it only seems to work if I have a node with address 0 configured as well. without either one, it doesn't seem to work as...
Well jeez, after fooling around some I discovered 2 errors in my original configuration. First was the node number. address 0 in the arduino is...
Your comment about the USB issue is very helpful, as I've switched nano's and this inevitably leads to the issue you mention. I'll stick to using...
I checked, and yes. Will check the network metrics per your suggestion. Thanks everyone so far! Will be back later with results
So it's not the code :D vindication it would be weird that both nano's apparently have this issue. I'm almost thinking SD card or JMRI install...
No, not using any shift registers. Just using a stock nano (old bootloader). Tried with 2 different nano's and have th e same result. I'm thinking...
I am currently connecting the sensors and LED's directly to the arduino pins. No Shift registers or multiplexers or anything like that in between....
Valid suggestion, I failed to mention I checked this :) I set the baud rate at the same rate used in the sketch (9600)
just to verify I am understanding correctly: the inputs are on card 3 of node 1. so output 1 is 1001 and input 1 is also 1001 or am I misreading...
Just to simply verify the issue I've tried using the default example sketch. This is how it's supposed to work, and still I see no bits received...
I'm assuming your code is largely based on the example code provided with the library. Mine is too. My code does exactly the same (minus the...
Hi All. I don't know if the way I'm trying to do thing is too outdated, but I'm having an issue using CMRI with JMRI. I've set up an arduino...
how's it going? any progress?
after a night of letting my Pi idle i can at least say the USB connection seems to be more reliable than haba's build. If there's a beta with...
Have just uploaded DCC-EX that's currently on github to my mega and so far it works well. Still not detecting the cutout properly but I think the...
yes I would like to test it out if it runs on an Arduino Mega with V3 motorshield... I think atani mentioned it should be capable of generating...
Has anyone been able to implement the cutout on the DCC++ Mega+genuino motor shield combination?
My guess is I don't have a command station that generates a cutout, thus the window is always open or closed, and data is always being read? On a...
Well this library has a lookup table too (the quick decode).. and I believe hamming codes are similar in the sense that it uses 3 out of 8 bytes...
so I read up on hamming codes, is that similar? it's the only thing I could find with google. As far as I grasp the material, the 4/8 coding is a...
