Cut the ends open. 50' ramp. Autoracks are 2 level versions. long, 7' wide. -We Honest- cars
Inside of open end. Plastic is thick in the corner so deeper cuts here.
Cut the bottom about the thickness of the door. CUT AT AN ARC, like the door. Plastic is thick. Use a #11 thinner blade to mininize distortion...
Cut the ends open. Plastic is thick. Use a #11 thinner blade to mininize distortion from digging so deep. #24 blade is too thick. Plastic is...
AZL Autoracks on 14 inch (35cm) and 17" (43cm) radius views. 9 cars to make a semi-circle on the 14", 11 cars would make the...
This N scale Plate Girder bridge is scaled so much smaller than all the other N scale bridges (Atlas, Model Power, etc). Detail is Super high....
From N-Scale Architect (Walthers 716-50045). Ethcing shown with Z scale figures, MTL flex roadbed for scale compare. Horizonatal rails are 2'...
A real pain to install. Very small clearance from side of motor housing to inside of shell. Mount as low as you can, bottom of shell's edge. They...
Side emitting Amber LEDs CA'd to the side of the plastic motor housing. It will JUST clear the side of the shell when it is on. Use magnet wire...
mount a large LED at the middle of a piece of styrene. Mount an SMD resistor here or wire one in back near the motor contacts because there is no...
Lenz Silver Mini, Digitrax DZ125 or CT Elektronik are the only ones that will fit under the cab roof. CT Elektronik is the smallest but will have...