Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from below.
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from above.
West side to the closet. This is the second attempt at cutting this piece. I cut this large, then trimmed the front to match up with the l-girders.
South gap. Cut plywood to fill south gap. Added some shims to get the front to back level.
Bolted valance frames sitting on the deck.
Last section of south deck installed. Oops I cut it 1" too short.
East and South valance frames drilled for attaching togehter.
East and South valance frames clamped for drilling.
East valance frame skin added.
East valance frame.
South valance frame in progress.