Hi I have attached a picture of my Z scale layout and need help with the wiring. I understand how to put the lighting in but need help where the wires go to prior to the on/off switch. Is there a block I can put all the wiring in and also the turnouts then to the switch? Also on occasion on my second hand turnouts that i have cleaned with electrical alcohol, when the train is at a stand still wont then move when i turn the controller power to full, is this a case i need to clean the track another way? thank you for you help with this Regards Gary
Hi, With your stalling train, does it move if you give it a push? Does the train run over the turnout if you start if before the turnout? Regarding your wiring question, I am not quite sure what the issue is; can you elaborate?