Just curious if anyone has tried to put the RP SD60M shell on an Athearn Genesis power frame. If so, how much fidgeting is there to make it fit......
I'm going to remove the jumpers and keep it as an EX version, continue testing Lyle
I suspect I did the EX version with the expectation that is was simply 'better'. Did no research into any hardware changes that might have been...
To be honest , I'm not sure if I installed the Classic version or DCC-EX. I found the EX versions while searching and downloaded the installer. It...
A bump of this topic. I had let the DCC++ system I have sit idle for a long while. A few days ago I pulled it back out and searched for updated...
I'm going on faulty memory here, but is the RR that still has daily service on narrow gauge to Vienna? Some time ago I watched a travel show that...
not to hijack this thread, but have there been any developments by the persons named here or others that have improved the programming...
Been away for quite a bit so I'm not aware if there have been any significant changes, but .... has there been any refinement in the DCC++ system...
The size capacitor depends on your needs/desires. Up to a point, bigger is better. The 100uF cap is respectable for very short interruptions, but...
The LED that has the resistor already wired, what voltage is it intended for? 12V? Is it a single color LED, or a bicolor? If the resistor/LED...
Whichever side of the motor was originally connected the the right side rail is the 'plus' and would get the orange wire. The side of the motor...
I'll add a spin to Rick's good advice. If you can solder two pieces of track together and drop a feeder from that joiner and do this for your...
If you want to have two (or more) locos on a small layout, DCC is the way to go if you want ease of wiring as well as more 'realistic' operation....
Maybe not the best title for the subject, but .... I'm wondering if there are any known sources and/or sites that are related to developing DCC++...
Crusader, thanks for the research and update. I was just coming in today to see if there had been any changes in this thread. I am also going to...
BTW, one of my problems has not been reading, but WRITING indexed CVs. This can happen if I do a "write full sheet" on the CVs tab. This happened...
I'm going to continue to research as best as I can, but I believe without deep effort by someone more knowledgeable than I am that DCC++ is going...
A little more evaluation. I'm coming to the conclusion the indexed CVs and the Arduino software don't always get along. That may be decoder brand...
My coworker has encountered difficulty reading a WOW decoder, no keep-alive connected. His reads single CVs fine, but has difficulty reading...
So far everything tested has been reading fine. One qualified exception has been a Econami 2000 decoder when DecoderPro tries to read indexed CVs....
