Oh! The vertical uprights for the adjustable shelving.
Made a couple quick idea tweaks to add some interest [ATTACH]
The backdrop will be mounted to the modules but pushed back against the walls. I already have double track standards mounted up. Ben
Nope. These are my own toys. If I join a club I'd build one for that eventually. These are for me an the family plus the lengths due to the...
Potential Concept: This would be an end unit that would have a duck under to the next module coming out of the tunnel end due to closet [ATTACH]
Fascia would be on the modules on the front side (and ends if needed) then also there would be backdrops attached to the back side of the module. Ben
So life as usual has screwed things up over the past months but I'm now getting back to working on my shelf-around the room layout. I was looking...
Just announced they are shipping! C&O T-1 2-10-4 with Paragon 2 sound from Broadway!...
So the first module is done. I have three that have shelving underneath so they are taking a bit longer than I expected. I'm hoping to get the...
What are you using as the top of your modules?
Thanks, oldrk!! I just ordered it!
If you have time, I'm hoping to have some of those tiles in this weekend. I think.....If everything goes right....and zombies don't show up!
Ron, I've read a couple articles about it and they said to treat it like homasote. Make sure you seal it and the tile will be fine. I'm actually...
You guys are awesome. I have been on COHS but either didn't have the patience to look through the photos or was running the wrong search! Guess...
Absolutely Greg! If I wasn't renting it would be a different story. Same if I had a tablesaw I trusted.
My friends, I have found so much conflicting information about coal cars I'm very confused and was hoping you folks might be able to help me out....
Honestly Ron, it's a crapshoot. I'm guessing for 4.42 those will be full of knots and splits. The more knots the more susceptible to warping....
Nice looking benchwork! Don't sell yourself short that is well constructed. I also agree on the 90 degree clamps. I use one but it makes a tone...
So here is what I did. The table tops and 'shelf supports' are made from 1x4 quality lumber. However the legs are made from 1/2" plywood that...
Remember I said no more benchwork changes? Well guess what? The 2x3 dimensional lumber legs are warped. When I was trying to add the second...
