The Kato double truss bridge comes with a truss connector that you can use to make a it appear as if two individual trusses were a single truss...
There is a hobo camp under the SP bridge near the east portal of the Palisade tunnels.
A pair of westbound Cotton Belt B40-7's cross the Humboldt River on the west side of the Palisade tunnels.
Started with stairs from a Pola kit then am scratch building the bridge deck.
This finished bridge will be eventually used in a future expansion of the layout.
When completed this bridge will be used in the next expansion of the layout on the east side of the Palisade tunnels.
These are the stl files I used to build my n-scale model of the Burlington Iowa swing span bridge. The fixed span has a bottom, 2 sides, 2 top...
Hello everyone! In 2016, I decided to take the California Zephyr from Emeryville to Reno. Since I was getting into trains at the time, I thought...
A pair of SP C44-9W's with an stack train cross the Humboldt River on a 200 ft through truss bridge in the Palisade Canyon. The bridge is a BLMA...
Another angle of the segmented concrete bridge on the SP line at Golconda.
This is the scratch built segmented concrete bridge on the SP line at Golconda. Base scenery has been started.
Central Valley Model Works bridge at Golconda. This is looking east. Piers for the segmented concrete bridge are seen at the rear covered in...
Scenery has started on the Golconda section. This view of a Central Valley Model Works bridge from east side of the Humboldt River looking west.
Approach bridges. Trusses are bashed Kato thru-truss. Piers are poured plaster.
Shows part of the thru-truss bridge modeled from a BNSF bridge in Sioux City IA. The approach bridges are bashed Kato thru-trusses. Piers are...
