With Digitrax DN163A3 Decoder
I had problem keeping these in contact with the decoder. So I soldered a blob to the decoder motor contacts.
I had problem keeping these in contact with the decoder.
SW8 fitted with a DZ123 decoder. The decoder doesn't fit. But the install works.
Showing finished install. Also shows routing and connection points of blue, white, and yellow wires. Note: there is an additional yellow wire...
Orange lead inserted into right brush cap.
Grey lead inserted into left brush cap.
Showing solder points of red and black leads.
Showing routing of red and black leads along either side of the gear tower.
Circuit board cuts are highlighted.
Tam Valley Depot Singlet Servo Decoder
DS64 wired with eurostyle terminal strip. The purpose of this setup is to make it easy to wire panel lamps and push button switches.