Trying to fit my 4.5'x 8' layout to the Bend Track Modules. This "Table" Layout was built from three N-Trak modules I use to have, but...
Trying to fit my 4.5'x 8' layout to the Bend Track Modules.
Trying to fit my 4.5'x 8' layout to the Bend Track Modules. Failed 1st design of the connector area.
Trying to fit my 4.5'x 8' layout to the Bend Track Modules. Sorry but the Orbes in the photos are just dust, not ghost.
Bend Track Wall Module is used to tie the Bend Track modules to the home layout. They were too long to fit in one room with the table layout so...
The 4' balloon module hooked to the wall module
Tucker Hollow is a small spot on the railroad. It's tucked into the hollow between two mountains and sports an abandoned depot, an enclosed water...
This view shows Deer Creek and the bridge leading to the tunnel.
A higher view of the roughed in Deer Creek, as seen from the ridge above.
This is the Deer Creek area as seen closer to track level. The track descends downhill at this point before crossing the creek and entering the...
2x4 foot layout in Atlas code 80
Rodneys Railroad Tools 3-N-1
Rodneys Railroad Tools Mystery Tool
Rodneys Railroad Tools Straight Track
Rodneys Railroad Tools Turnout Alignment Tool
Rodneys Railroad Tools Track Feeder Drill Jig