I must be missing something and will likely kick myself once I realize what it is. I bought three Wabbits to run three Tortoise. They run great on the primary plus first three route addresses. The documents state I can program 13 routes, yet I cannot get route 4 or 5 to respond. I think I have followed the directions fairly well on the steps to take and developed charts to create proper programming CV values. A strange result is that the two Wabbits that were not set to program took the reset commands and went back to defaults. Any hints, tips, or hand across the back of my head would be appreciated.
I'll use Digitrax Routes for now. Hopefully I don't need more than 64 routes as the 210+ is restricted to. I wonder if I can use one output to drive two tortoises? I'll have to experiment on this one. I only have three more tortoise units so I may buy one more Wabbit. Smails or Cobalt IP Digitals will be used going forward.