I have run a lot of Digitrax radio throttles and notice that sometimes it will hesitate before it takes the command. Has anyone else noticed this?
I also have the Digitrax DT100R throttle. As I understand it, new speed information is not sent to the command station until you stop turning the knob. As far as pressing buttons, I haven't noticed any delays. I have had problems getting track power to turn on and off. I usually have to press the 2 buttons several times for anything to happen.
I will pass your info on, as some, other than myself have noticed this. Perhaps the solution is to do smaller increments on the throttle, then stop, then do it again.