This pictures shows the yellow LED that needs to be removed, but on the opposite side of the board. I accidentally took a picture of the rear end of the board. Use the short end of the board to remove the LED. Once you flip over the shell, there is a metal plate that needs to be removed or pointed up. Part of it is glued down, so what I did was to get some very fine needle-nose pliers and flip up the metal plate. Here is the metal plate flipped up. This is the LED that I used. Very tiny. Route the LED wires through the large hole in the metal plate. It's the one in the front by the front headlight for Santa Fe units. The LED hooked up to the correct pads on the circuit board.
