Search Results

Search Again
Page 1 of 10
  1. Trainforfun
    Thread

    DCS100 Loconet off ???

    Hi These days I am working hard on the layout ( 16' x 16') to find a short circuit that came in suddenly , intermittent at first but now solid...
    Thread by: Trainforfun, Aug 19, 2023, 2 replies, in forum: DCC & Electronics
  2. Trainforfun
    Post

    Creeping throttle....

    One of my Digitrax DT400 put a speed value of 7 sometimes after I "zeroed" the speed . Since I saw that I always double check . When I go out of...
    Post by: Trainforfun, Oct 29, 2014 in forum: N Scale
  3. Trainforfun
    Post

    I've gone DCC at last!

    You did a good move Bob ! When I did the transition to DCC I kept some toggle switches for the locomotives servicing section so locomotives are...
    Post by: Trainforfun, Aug 11, 2014 in forum: N Scale
  4. Trainforfun
    Post

    What makes a "Collectible" valuable?

    Yes I know but I had to look at both sides ... In fact their plastic boxes are not very airthight ! I will sell it $ 500,000 instead of $ 1...
    Post by: Trainforfun, May 6, 2014 in forum: N Scale
  5. Trainforfun
    Post

    Scratchbuild a UFO

    Don't forget to build the mountain around using mashed potatoes , sorry your story reminds me of a movie ! Really you are probably the only here...
    Post by: Trainforfun, May 6, 2014 in forum: N Scale
  6. Trainforfun
    Post

    What makes a "Collectible" valuable?

    I have an MT box car that is misprint on one side , I am keeping it in a drawer , opened it only once and saw the difference . I doubt it will...
    Post by: Trainforfun, May 5, 2014 in forum: N Scale
  7. Trainforfun
    Post

    Amhurst Train Show!

    Thanks Mike for the beautifull pic !!!!
    Post by: Trainforfun, Jan 29, 2014 in forum: N Scale
  8. Trainforfun
    Post

    Amhurst Train Show!

    Thanks for the pictures
    Post by: Trainforfun, Jan 29, 2014 in forum: N Scale
  9. Trainforfun
    Post

    Those Poor Santa Fe Locos

    Super job !!! I wish I had your talent to do that on some of my units .
    Post by: Trainforfun, Oct 13, 2013 in forum: N Scale
  10. Trainforfun
    Post

    Heljan roundhouse conversions.

    The best way is to work with the center of the future or existing TT . Install your roundhouse on a sheet of paper ( big enough for the...
    Post by: Trainforfun, Nov 16, 2010 in forum: N Scale
  11. Trainforfun
    Post

    IMRC CN SD40-2W photos up on website!

    When you install DCC to IM F units you have to solder the stock LED to the new board . It's not a big thing for some modelers but it is to others...
    Post by: Trainforfun, Nov 10, 2010 in forum: DCC & Electronics
  12. Trainforfun
    Post

    Super Chief Consist Order

    Here is a U Tube video of the ATSF Super Chief : http://www.youtube.com/watch?v=PNyAQir_dfo
    Post by: Trainforfun, Nov 10, 2010 in forum: N Scale
  13. Trainforfun
    Post

    IMRC CN SD40-2W photos up on website!

    Thanks all for the pictures , RAM53 , you did a real nice job with the ditchlights ! How does it run , is it comparable to an Atlas 6 axles or...
    Post by: Trainforfun, Nov 7, 2010 in forum: DCC & Electronics
  14. Trainforfun
    Post

    Experience with DZ123?

    Using 24 volts for your N scale layout is way too high , I think you should invest in a better power pack to save your units ! On my Digitrax...
    Post by: Trainforfun, Oct 7, 2010 in forum: N Scale
  15. Trainforfun
    Post

    Experience with DZ123?

    I would try to switch off the "helping" start by putting back CV2 to a value of 0 .
    Post by: Trainforfun, Oct 5, 2010 in forum: N Scale
  16. Trainforfun
    Post

    How about some CN!

    Here is the same train on their way back : [img] [img]
    Post by: Trainforfun, Oct 5, 2010 in forum: N Scale
  17. Trainforfun
    Post

    How about some CN!

    Here is some from me , I just realized I did not took many pictures of them lately : [img] [img] These were taken on a special executive...
    Post by: Trainforfun, Oct 5, 2010 in forum: N Scale
  18. Trainforfun
    Post

    UPRR Geneva Subdivision Trackplan

    Thanks a lot !
    Post by: Trainforfun, Sep 24, 2010 in forum: Layout Design Discussion
  19. Trainforfun
    Post

    UPRR Geneva Subdivision Trackplan

    Hi Darryl , could you post a link for SMD signals .
    Post by: Trainforfun, Sep 23, 2010 in forum: Layout Design Discussion
  20. Trainforfun
    Post

    Quick question on soldering to Athearn P59PHI

    What kind of DCC system do you have ?
    Post by: Trainforfun, Aug 18, 2010 in forum: DCC & Electronics
Showing results 1 to 20 of 197 Next >
Search Again
Page 1 of 10