Search Results

Search Again
  1. dowish
    Post

    What are your new locos?

    Thanks. I got into trains living in the Portland, OR area. When I can build a "permanent" layout, P&W will handle local switching duty, while UP...
    Post by: dowish, May 24, 2011 in forum: N Scale
  2. dowish
    Post

    What are your new locos?

    Two Portland and Western SD9's came in from Atlas last week.
    Post by: dowish, May 22, 2011 in forum: N Scale
  3. dowish
    Post

    N Scale "Whats on your Mainline?"

    I have always got to be careful of what obstructions might be on the main... Dodging catzilla, UP #8444 heads a mixed freight..
    Post by: dowish, May 22, 2011 in forum: N Scale
  4. dowish
    Post

    Kato SD70ACE decoder problems

    I have two ACe's and am using the K1C in both. Neither board physically fit well, and I had to put the shell back on before they would...
    Post by: dowish, Jul 25, 2009 in forum: N Scale
  5. dowish
    Post

    Problems Matching Start Voltage

    Thanks, changing CV57 worked. Now a little tweaking to get the mid-range speed and I'm good to go.
    Post by: dowish, Mar 5, 2009 in forum: DCC & Electronics
  6. dowish
    Post

    Is there a trick to programming the Athearn Challenger (N scale)?

    The Athearn Big Boy and from what I've seen and heard the Challenger also, do not support CV read. I also have to use ops mode programing, at...
    Post by: dowish, Mar 4, 2009 in forum: N Scale
  7. dowish
    Thread

    Problems Matching Start Voltage

    I have an Atlas GP38 and GP9 that I plan on running MU’ed as my local freight. I’ve managed to match the top speeds to ‘close enough.’ The GP9...
    Thread by: dowish, Mar 3, 2009, 4 replies, in forum: DCC & Electronics
Showing results 1 to 7 of 7
Search Again