I played with it some more after a break and have control over it again. Thanks.
In trying to figure out how to use extended addresses on a factory installed decoder in a Spectrum SD45-2, i changed the address to an unknown...
I have a Spectrum SD45 not DCC ready, i want to install DCC & sound. I'm i wasting time /money and should invest in a Athearn SD45? If the...
Thank you, i gave it a rest for an hour, then started to play with it again and i found out just what you told me. I deleted four sections &...
Built a layout on XTrkCad, when i run the train it comes to a point and stops. Message says end of line but it isn't. When i "Join" the connection...
I went with a Prodigy Advance 2 Squared. Can't wait to try it.
I checked the local library, MOTHERLOAD! I checked out six books, all from Model Railroad Magazine Books, & two DVD's. Look out, now i'm dangerous...
Thank You! Yes, it was helpful. I will read the other web pages you recommended.
I will be using Atlas turnouts for my first layout and there are few terms i'm not sure about. 1. What part is the Frog? 2. Differents in use...
I will be using Atlas turnouts for my first layout and there are a few terms i'm not sure about. 1. What part is the "Frog" 2. Difference in...
What you anyone tell me about RSO brand trains(or maybe locomotives). I have seen only two locomotives and never rolling stock. All that was on...
Does anyone know a source for Rivarossi models of other countries? Looking for a Valpore DII 0-3-0. It's a German steam locomotive.
Thanks for the info, i was wondering about the rear set of drivers swiveling. Looking at the model, i saw the front set has a swivel connection...
I made my first articulated steam locomotive purchase a few days ago. Like the rest of my collection, i choose Rivarossi, a Challenger 4-6-6-4...
I may be young but i'm was "old school" with my trains, i never paid much attention to DCC until after i made that first post asking about power...
I have a small collection of Rivarossi Steam Engines that i usually run once a year(Christmas) but now would like to set up a permanent layout...
I was also thinking of trying LEDs. I haven't done it yet but some infomation in case you didn't know. LED come in different brightnesses measured...