Does anyone know if the Micro Trains GP35 shells will fit on the GP9 chassis/frame? I have a few GP9's and would like to convert one to a GP35 if...
load on 89' flatcar carrying 30 frames from JLG. Was a great project converted 5 truckloads to one railcar.
Valance frame
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from below.
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from above.
West side to the closet. This is the second attempt at cutting this piece. I cut this large, then trimmed the front to match up with the l-girders.
South gap. Cut plywood to fill south gap. Added some shims to get the front to back level.
The view from the door. This the East deck looking South. PCC Logistics will be front and center.
Adding permanant support inverted shelf brackets.
The valance with temporary supports across the front.
Hoisting up the valance.
East and South valances with top skins.
South valance gets a top skin.
East valance gets a top skin.
l-girder ledger boards for the valance.
Bolted valance frames sitting on the deck.