A heavy duty drop bottom trailer is being unloaded at the Halliburton barite facility in Battle Mountain, Nevada
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from below.
Valance curve. I cut 3/4" plywood and a couple of mounting boards to make the curved portion of the valance. As seen from above.
West side to the closet. This is the second attempt at cutting this piece. I cut this large, then trimmed the front to match up with the l-girders.
South gap. Cut plywood to fill south gap. Added some shims to get the front to back level.
Foam support for the valance corner. Just a little extra bulk to help keep this section from getting damaged.
West deck. Looking west.
West deck. The deck jut's into the window sill to give me 3" extra depth in this area.
West deck. I had a few tricky cuts on this peice. This was actually my second attempt at this monster of a peice. It fits just right now.